Calibrating RC Helicopters
When calibrating rc helicopters, the controller needs to be set properly otherwise it will not calibrate properly so the following settings need to be
set on the controller
1. the left stick needs to be all the way down
2. the left vertical trim needs to be all the way down
3. The rev switches, both the bottom front right on your controlled need to be down put to DOWN, UP, DOWN, UP in that order starting from the left and then the right
4. If you rc helicopter is a 6 inch model then the idle switch which is found on the top left of the controller is set to the off position
Once these settings have been put in place, then turn on the controller and then you should connect the battery to the rc helicopter. You should find a red light on the
Receiver will flash a couple of times before turning green
If you complete all these settings and the calibration is still not set, then complete the following checks
1. The rc helicopter battery is fully charged
2. The same for the controller batteries
3. The frequency plug is inserted into the receiver properly
4. The same for the controller
5. Both the frequency and receiver number matches both
6. All the buttons on the first section above are correct and not just set half way. You can check this by turning them in the opposite direction and then back again
7. The controllers Ariel has been fully extended
If after all these checks it still does not work, contact the supplier